Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 133 — Lexmark C762

Code: 133

Description: Fuser Error Fuser cold roll - BUR
Remedy: 1 Measure the voltage on connector J33-12 on the system board. The voltage should measure approximately +0.13 V dc to +0.64 V dc as the backup roll lamp turns off and on. Is the voltage correct? Go to step 2 Replace the “System board”. 2 Remove the fuser from the printer Check continuity of the backup roll by measuring between pins 1 and 5 on the AC fuser connector on the fuser assembly. Is there continuity? Go to step 4 Go to step 3 3 Check to make sure that the backup roll lamp is installed correctly. Is the backup roll lamp installed correctly? Go to step 4 Install the lamp correctly. If this does not fix the problem, replace the “Fuser assembly”. 4 Reinstall the fuser assembly. Watch to see if the lamps turn on and off as the lamp heats up. Do the lamps turn on? Go to step 5 Replace the “LVPS assembly”. 5 Turn the printer on and allow it to reach a Ready prompt. Note: The printer may not complete POR and continues to display the error code. Remove the fuser assembly from the printer. Measure the voltage on connector J33-7 on the system board. The voltage should measure approximately +3.3 V dc. Is the voltage correct? Go to step 6 Replace the “System board”. 6 Measure the voltage on the fuser DC control connector on the LVPS. Measure the voltage on pin 7 of the connector. Does the voltage measure approximately +3.3 V dc. Replace the “Fuser assembly”. Replace the “LVPS assembly”.

← Xem tất cả mã lỗi Lexmark C762

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie