Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 167 — Lexmark C762

Code: 167

Description: Motor The incorrect configuration ID.
Remedy: 1. Enter Diagnostic mode. See “Entering Diagnostics mode”. 2. Select PRINTER SETUP. 3. Select Configuration ID. 4. Increase the last two digits each by four. The left digit blinks, indicating it is the first digit to be changed. Press Select to accept the current value and skip to the next digit. Change the two digits on the right to increase each of their values by four. For example, in this case, change 123456 to 12349A. To change the value of a digit, press Menu until the desired value is displayed and press Select. When the last (rightmost digit) is changed and Select is pressed, the new value is set. The printer automatically begins POR. 5. Turn the printer off. 6. Open the fuser access cover. 7. Unlatch the two fuser latches (A). 8. Remove the fuser assembly. 9. Open the front cover. 10. Remove the yellow print cartridge. 11. Remove the front right light shield screws (B) and (C) and remove the light shield. 12. Carefully remove the paper path access door cover right mounting screw (D). 13. Tape front jam access door (E) if tape is available, to help hold the door in place. 14. Remove the front right handle cover assembly screws (F) and remove the assembly. 15. Open paper tray. 16. Remove screw (G) from the top front support bracket. Swing bracket to the right. 17. Use the alignment pins (H) on the web oiler fuser motor assembly to position the assembly in holes (J) and install the assembly. 18. Secure the web oiler motor assembly with screws (K). 19. Install the web oiler card using screws (L). 20. Plug web oiler cable into web oiler card connector (M). Plug web oiler drive assembly cable into cable connector (N). Note: Make sure the cables from the drive assembly are routed along the lower frame and are not in contact with the drive assembly gears. 21. Reinstall paper path access door. 22. Align tabs on the front right light shield with the slots (O) on the frame. 23. Move the front right light shield up until alignment stud (P) and the screw hole (Q) are aligned. 24. Attach the new fuser web oiler fuser housing (R) to the new web oiler fuser. 25. Insert the web oiler fuser assembly into the fuser assembly and install the fuser assembly into the printer.

← Xem tất cả mã lỗi Lexmark C762

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie