Code: 200.04
Description: S2 sensor wasn’t made within timeout period. This message indicates that a paper jam has occurred at or near the printer input sensor. Open the printers left door (Paper Jam Removal Door) to access the jammed media.
Remedy: 1 Check the tray for proper edge guide setting and media loading. Edge guides should be adjusted against edge of media. Media should be fanned and lay flat in the tray. Is the media properly loaded in the tray? Go to step 2 Properly load media. 2 Check the pick tires for contamination or wear. Are pick tires worn or contaminated? Replace the pick rolls. See “Pick rolls removal”. Go to step 3 3 Check for obstructions in the paper path. Is the paper path obstructed? Clear the obstruction. Go to step 4 4 Is the inner deflector out of position? Correct the deflector position. Go to step 5 5 Is the autocompensator damaged or defective? Go to “Autocompensa tor service check” Go to step 6 6 Perform the “BASE SENSOR TEST” on the S2 sensor. Does the S2 sensor pass the test? Contact your next level of support. See “200.21, 200.28, and 200.29 paper jam service check.