Description: Near narrow media sensor is made when the printer tries to print from an idle state. Possible causes: • Paper jam leaving paper over the sensor • Defective near narrow media sensor • Faulty system board
Remedy: 1 Open the left access door. Check the sensor flag for damage. A—Input sensor B—S1 sensor C—Narrow media sensor D—Near narrow media sensor Is the sensor flag damaged? Replace the input sensor. See “Sensor (input, S1, narrow media, near narrow media) removal”. Go to step 2. 2 Turn the printer off, and open the system board shield. Check the cable in connector JPP2 for proper connection to the system board. Is the cable properly connected? Go to step 3. Reseat the cable. 3 Check the cable in connector JPP2 for damage. Is the cable damaged? Replace the paper path cable. See “Paper path cables”. Go to step 4. 4 Remove the staging deflector assembly, and check the sensor cable connection. See “Staging deflector assembly removal”. A—Input sensor B—S1 sensor C—Narrow media sensor D—Near narrow media sensor Is the cable properly connected? Go to step 5. Reseat the cable. 5 Replace the sensor. “Sensor (input, S1, narrow media, near narrow media) removal” Does the error reoccur? Replace the system board. See “System board removal”. Problem solved.