Description: 231.01 D1 sensor is made when printer tries to print from an idle state. Possible causes: • Damaged D1 sensor • Faulty system board 231.02 D1sensor is made early Possible causes: • Incorrect paper settings • Defective D1 sensor 231.03 D1 sensor is never made. Possible causes: • Improper loading of paper • Damaged paper D1 sensor • Faulty system board 231.04 D1 sensor broke early. Possible causes: • Damaged D1 sensor Faulty fuser • Faulty system board 231.05, 231.07 D1 sensor never broke. Possible causes: • Damaged D1 sensor • Faulty fuser • Faulty system board 231.08 D1 sensor is never made.
Remedy: 1 Open the left access door, and open the duplex assembly. Is the D1 or D2 flag damaged? Replace the damaged sensor. See “Sensor (D1, D2, and fuser bubble) removal”. Go to step 2. 2 Open the system board shield. Check the cable in connector JDP1 for proper connection to the system card. Is the cable properly connected? Go step 3. Reseat the cable. 3 Check the cable for damage. Is the cable damaged? Replace the duplexer cable. To access the cable, see “LVPS exit duct removal” and “Left cover removal”. Go step 4. 4 Remove the duplex cable cover. Check the cable for proper connection. Is the cable connected correctly? Go to step 5. Reseat the cable. 5 Check the cable for damage. Is the cable properly connected? Replace the duplexer cable. To access the cable, see “LVPS exit duct removal” and “Left cover removal”. Go to step 6. 6 Replace the duplex assembly. See “Duplex assembly removal”. Does the problem persist? Replace the system board. See “System board removal”. Problem solved.