Remedy: • Install the fuser. Replace the fuser if the problem persists. • If the problem continues, turn the printer off and remove the system board shield. See “System board shield removal”. Check the cable in connector JFSR1 (D) for proper connection to the system board, the cable for pinch points, and the cable or the connector for any other damage. If the connector is damaged on system board, replace the system board. See “System board removal”. If the fuser cable is damaged, replace the cable. • Check for continuity in the fuser cable. If continuity is not present, replace the fuser cable. If the problem persists after replacing cable, replace the system board. See “System board removal”.