Code: 147.01...147.05
Description: 147.xx Service Staging Motor Staging motor error 147.01 Service Staging Motor Staging motor has exceeded the ramp up table. 147.02 Service Staging Motor Staging motor has exceeded number of encoders at minimum PWM. 147.03 Service Staging Motor Staging motor has exceeded number of encoders at maximum PWM. 147.04 Service Staging Motor Motor encoder count did not change between interrupts. 147.05 Service Staging Motor Staging motor has encountered a stall time out.
Remedy: Step 1 Turn the printer off, and then remove the rear cover. See “Rear cover removal”. Check the table at JSP1 on the controller board for proper connection. Is the cable properly connected? Go to step 3. Properly connect the cables, and POR the printer. Go to step 2.
Step 2 Did the printer function correctly after reconnecting the cables? Problem resolved. Go to step 3.
Step 3 Turn the printer on, and then verify the following approximate values at JSP1: Pin 2: +24 V dc Pin 4: +24 V dc Pin 5: +5 V (when paper is picked) Pin 7: Ground Pin 8: Ground Pin 10: +5 V dc Pin 12: _5 V dc (when paper is picked) Pin 15: +5 V dc Pin 16: Ground Are the values approximately correct? Replace the paper pick motor drive assembly. See “Paper pick motor drive assembly standard tray removal”. Replace the controller board. See “Controller board removal”.
Step 2 Did the printer function correctly after reconnecting the cables? Problem resolved. Go to step 3.
Step 3 Turn the printer on, and then verify the following approximate values at JSP1: Pin 2: +24 V dc Pin 4: +24 V dc Pin 5: +5 V (when paper is picked) Pin 7: Ground Pin 8: Ground Pin 10: +5 V dc Pin 12: _5 V dc (when paper is picked) Pin 15: +5 V dc Pin 16: Ground Are the values approximately correct? Replace the paper pick motor drive assembly. See “Paper pick motor drive assembly standard tray removal”. Replace the controller board. See “Controller board removal”.