Code: 166, 168
Description: 166.80 The motor (tray 2 pass-through) did not turn on. 166.81 The motor (tray 2 pass-through) did not turn off. 166.82 The motor (tray 2 pass-through) speed did not ramp up to the required level. 166.83 The motor (tray 2 pass-through) stalled. 166.84 The motor (tray 2 pass-through) ran too slow. 166.85 The motor (tray 2 pass-through) ran too fast. 166.86 The motor (tray 2 pass-through) did not run at the correct timing. 167.80 The motor (tray 3 pass-through) did not turn on. 167.81 The motor (tray 3 pass-through) did not turn off. 167.82 The motor (tray 3 pass-through) speed did not ramp up to the required level. 167.83 The motor (tray 3 pass-through) stalled. 167.84 The motor (tray 3 pass-through) ran too slow. 167.85 The motor (tray 3 pass-through) ran too fast. 167.86 The motor (tray 3 pass-through) did not run at the correct timing. 168.80 The motor (tray 4 pass-through) did not turn on. 168.81 The motor (tray 4 pass-through) did not turn off. 168.82 The motor (tray 4 pass-through) speed did not ramp up to the required level. 168.83 The motor (tray 4 pass-through) stalled. 168.84 The motor (tray 4 pass-through) ran too slow. 168.85 The motor (tray 4 pass-through) ran too fast. 168.86 The motor (tray 4 pass-through) did not run at the correct timing.
Remedy: Step 1 Reset the printer Does the problem remain? Go to step 2. The problem is solved. Step 2 Check the connections between the motor (tray [x] transport) and controller board. Is the motor properly connected? Go to step 4. Go to step 3. Step 3 Reseat the cable. Does the problem remain? Go to step 4. The problem is solved. Step 4 Check the motor (tray [x] transport) cable for damage. Is the cable free of damage? Go to step 6. Go to step 5. Step 5 Replace the cable. Does the problem remain? Go to step 6. The problem is solved. Step 6 Reset the printer. Does the problem remain? Go to step 7. The problem is solved. Step 7 Replace the motor (tray [x] transport). Does the problem remain? Go to step 8. The problem is solved. Step 8 Reset the printer. Does the problem remain? Go to step 9. The problem is solved. Step 9 Replace the controller board. Does the problem remain? Contact the next level of support. The problem is solved.