Code: 240.43
Description: Paper fed from tray 4 was picked but it never arrived at the sensor (MPF/pass-through).
Remedy: Step 1 a From the home screen, touch Settings > Device > Preferences. b Check if the paper size matches the size set on the tray guides. Does the paper size match the size set on the tray? Go to step 3. Go to step 2. Step 2 Change the paper size or adjust the size setting in the tray. Does the problem remain? Go to step 3. The problem is solved. Step 3 Check the paper path in tray 3 for paper jams and fragments. Is the paper path free of jams and fragments? Go to step 5. Go to step 4. Step 4 Remove the paper jams and fragments. Does the problem remain? Go to step 5. The problem is solved. Step 5 a Enter the Diagnostics menu, and then navigate to: Printer diagnostics & adjustments > Sensor tests b Find the sensor (MPF/pass.through). Does the sensor status change while toggling the sensor? Go to step 8. Go to step 6. Step 6 Check the sensor cable for proper connection and damage, and replace if necessary. Does the problem remain? Go to step 7. The problem is solved. Step 7 Check the sensor for damage and replace if necessary. Does the problem remain? Go to step 8. The problem is solved. Step 8 a Enter the Diagnostics menu, and then navigate to: Printer diagnostics & adjustments > Sensor tests b Find the sensor (Pass.through (tray 2)). Does the sensor status change while toggling the sensor? Go to step 11. Go to step 9. Step 9 Check the sensor cable for proper connection and damage, and replace if necessary. Does the problem remain? Go to step 10. The problem is solved. Step 10 Check the sensor for damage and replace if necessary. See gSensor (550-sheet tray pass-through) removalh. Does the problem remain? Go to step 11. The problem is solved. Step 11 a Enter the Diagnostics menu, and then navigate to: Printer diagnostics & adjustments > Sensor tests b Find the sensor (Pass.through (tray 3)). Does the sensor status change while toggling the sensor? Go to step 14. Go to step 12. Step 12 Check the sensor cable for proper connection and damage, and replace if necessary. Does the problem remain? Go to step 13. The problem is solved. Step 13 Check the sensor for damage and replace if necessary. See gSensor (550-sheet tray pass-through) removalh. Does the problem remain? Go to step 14. The problem is solved. Step 14 a Enter the Diagnostics menu, and then navigate to: Printer diagnostics & adjustments > Motor tests > Passthrough (tray 2) b Touch Start. Does the motor run? Go to step 17. Go to step 15. Step 15 Check the motor cable for proper connection and damage, and replace if necessary. Does the problem remain? Go to step 16. The problem is solved. Step 16 a Replace the motor (550-sheet tray pass.through). See gMotor (550-sheet tray pass.through) removalh. b Perform a print job. Does the problem remain? Go to step 17. The problem is solved. Step 17 a Enter the Diagnostics menu, and then navigate to: Printer diagnostics & adjustments > Motor tests > Passthrough (tray 3) b Touch Start. Does the motor run? Contact the next level of support. Go to step 18. Step 18 Check the motor cable for proper connection and damage, and replace if necessary. Does the problem remain? Go to step 19. The problem is solved. Step 19 a Replace the motor (550-sheet tray pass.through). See gMotor (550-sheet tray pass.through) removalh. b Perform a print job. Does the problem remain? Contact the next level of support. The problem is solved.