Code: 163, 164
Description: 163.80 The motor (tray 3 pick) did not turn on. 163.81 The motor (tray 3 pick) did not turn off. 163.82 The motor (tray 3 pick) speed did not ramp up to the required level. 163.83 The motor (tray 3 pick) stalled. 163.84 The motor (tray 3 pick) ran too slow. 163.85 The motor (tray 3 pick) ran too fast. 163.86 The motor (tray 3 pick) did not run at the correct timing. 164.80 The motor (tray 4 pick) did not turn on. 164.81 The motor (tray 4 pick) did not turn off. 164.82 The motor (tray 4 pick) speed did not ramp up to the required level. 164.83 The motor (tray 4 pick) stalled. 164.84 The motor (tray 4 pick) ran too slow. 164.85 The motor (tray 4 pick) ran too fast. 164.86 The motor (tray 4 pick) did not run at the correct timing.
Remedy: Step 1 Check the pick roller for misalignment and damage. Is the pick roller properly installed and free of damage? Go to step 3. Go to step 2. Step 2 Reinstall or replace the pick roller. Does the problem remain? Go to step 3. The problem is solved. Step 3 Check the cable for socket "INDEX/PAP OUT/PICK MTR" on the controller board for misalignment and damage. Is the cable properly seated and free of damage? Go to step 5. Go to step 4. Step 4 Reseat or replace the cable. Does the problem remain? Go to step 5. The problem is solved. Step 5 Reset the printer. Does the problem remain? Go to step 6. The problem is solved. Step 6 Replace the media feeder. See “Media feeder removal”. Does the problem remain? Go to step 7. The problem is solved. Step 7 Replace the controller board. See “Controller board removal”. Does the problem remain? Contact the next level of support. The problem is solved.