Code: 161, 162
Description: 161.80 The motor (tray 1 pick) did not turn on. 161.81 The motor (tray 1 pick) did not turn off. 161.82 The motor (tray 1 pick) speed did not ramp up to the required level. 161.83 The motor (tray 1 pick) stalled. 161.84 The motor (tray 1 pick) ran too slow. 161.85 The motor (tray 1 pick) ran too fast. 161.86 The motor (tray 1 pick) did not run at the correct timing. 162.80 The motor (tray 2 pick) did not turn on. 162.81 The motor (tray 2 pick) did not turn off. 162.82 The motor (tray 2 pick) speed did not ramp up to the required level. 162.83 The motor (tray 2 pick) stalled. 162.84 The motor (tray 2 pick) ran too slow. 162.85 The motor (tray 2 pick) ran too fast. 162.86 The motor (tray 2 pick) did not run at the correct timing.
Remedy: Step 1 Check the pick roller for misalignment and damage. Is the pick roller properly installed and free of damage? Go to step 3. Go to step 2. Step 2 Reinstall or replace the pick roller. Does the problem remain? Go to step 3. The problem is solved. Step 3 Check the cable for socket "INDEX/PAP OUT/PICK MTR" on the controller board for misalignment and damage. Is the cable properly seated and free of damage? Go to step 5. Go to step 4. Step 4 Reseat or replace the cable. Does the problem remain? Go to step 5. The problem is solved. Step 5 Reset the printer. Does the problem remain? Go to step 6. The problem is solved. Step 6 Replace the media feeder. See “Media feeder removal”. Does the problem remain? Go to step 7. The problem is solved. Step 7 Replace the controller board. See “Controller board removal”. Does the problem remain? Contact the next level of support. The problem is solved.