Code: 843.00
Description: The scanner carriage failed to return to its home position.
Remedy: Step 1 Turn off the printer. Does the CCD move and return to the home position? The problem is solved. Go to step 2. Step 2 a Enter the Diagnostics menu, and then navigate to: Scanner diagnostics > Sensor tests b Find the sensor (FB scanner home). Does the sensor status change while toggling the sensor? Go to step 4. Go to step 3. Step 3 Reseat the home position cable on the JHS1 connector on the controller board. Does the problem remain? Go to step 4. The problem is solved. Step 4 Reseat the cable on the JFB1 connector on the controller board. Does the problem remain? Go to step 5. The problem is solved. Step 5 Measure the voltage of pin 1 of the JFB1 connector on the controller board. Is the voltage equal to +24 V AC? Go to step 7. Go to step 6. Step 6 Replace the controller board. See “Controller board removal”. Does the problem remain? Go to step 7. The problem is solved. Step 7 Measure the voltage of pin 1 of the JHS1 connector on the controller board. Note: Pin 2 is GND. Is the voltage equal to +5 V AC? Go to step 8. Go to step 9. Step 8 Replace the flatbed. See “Flatbed removal”. Does the problem remain? Go to step 9. The problem is solved. Step 9 Replace the controller board. See “Controller board removal”. Does the problem remain? Contact the next level of support. The problem is solved.