Code: 360.60, 360.61
Description: 360.60 The motor (mid.transport) did not turn on. 360.61 The motor (mid.transport) did not turn off.
Remedy: Step 1 a Check the MSHPF for proper installation, and then check its paper path. See “Procedure before starting the MSHPF service checks”. b Enter the Diagnostics menu, select Output bin quick feed > select bin, and then touch Single or Continuous. Does the problem remain? Go to step 2. The problem is solved. Step 2 a Enter the Diagnostics menu, and then navigate to: Output device diagnostics > Motor tests > Finisher > Midtransport b Touch Start. Does the motor run? Go to step 5. Go to step 3. Step 3 Reseat the motor cable, and then check the motor for misalignment and damage. Is the motor properly installed and free of damage? Go to step 5. Go to step 4. Step 4 Reinstall or replace the motor. See “Motor (mid-transport) removal”1. Does the problem remain? Go to step 5. The problem is solved. Step 5 Check the mid-transport gear for misalignment and damage. Is the gear properly installed and free of damage? Go to step 7. Go to step 6. Step 6 Reinstall or replace the gear. See “Mid-transport gear removal”3. Does the problem remain? Go to step 7. The problem is solved. Step 7 Check the hole punch box belt for misalignment and damage. Note: Make sure that there are no other parts interfering with the movement of the belt. Is the belt properly installed and free of damage? Go to step 9. Go to step 8. Step 8 Reinstall or replace the belt. See “Hole punch box belt removal”. Does the problem remain? Go to step 9. The problem is solved. Step 9 Check the MSHPF standard bin exit belt for misalignment and damage. Note: Make sure that there are no other parts interfering with the movement of the belt. Is the belt properly installed and free of damage? Go to step 11. Go to step 10. Step 10 Reinstall or replace the belt. See gMSHPF standard bin exit belt removalh. Does the problem remain? Go to step 11. The problem is solved. Step 11 Check the pulley gears for misalignment and damage. Are the pulley gears properly installed and free of damage? Go to step 13. Go to step 12. Step 12 Reinstall or replace the pulley gear. Does the problem remain? Go to step 13. The problem is solved. Step 13 Check the offset assembly for misalignment and damage. Notes: . Move the offset roller from side to side to check for lateral movement. . Make sure that the offset roller belt is properly installed. Is the offset assembly properly installed and free of damage? Go to step 15. Go to step 14. Step 14 Reinstall or replace the offset assembly. See gOffset assembly removalh4. Does the problem remain? Go to step 15. The problem is solved. Step 15 Check the mid.transport interface board cables. . Reseat all connectors on the interface board. . Make sure that the cables are properly routed. Does the problem remain? Go to step 16. The problem is solved. Step 16 Replace the interface board. See gMid-transport interface board removalh5. Does the problem remain? Go to step 17. The problem is solved. Step 17 Check the interface board cables for cuts and damage. Are the cables free of damage? Go to step 19. Go to step 18. Step 18 Replace the cable. Does the problem remain? Go to step 19. The problem is solved. Step 19 a Reseat all connectors on the MSHPF controller board. b Make sure that the cables are properly routed, and then reset the printer. Does the problem remain? Go to step 20. The problem is solved. Step 20 Replace the MSHPF controller board. See “MSHPF controller board removal”. Does the problem remain? Contact the next level of support. The problem is solved.