Code: 430.19
Description: Stapler head fails to prime.
Remedy: Step 1 a Remove any jammed or loose staples, and then remove the partial slab of staples so only the full slabs remain. b Reseat the staple cartridge and the cartridge holder. c Check if the staple cartridge door is closed properly. d Reset the printer, and then reseat the staple finisher. Does the problem remain? Go to step 2. The problem is solved. Step 2 a Check the staple finisher staple cartridge holder for damage, and replace if necessary. b Reseat the staple cartridge. Does the problem remain? Go to step 3. The problem is solved. Step 3 a Enter the Diagnostics menu, and then navigate to: Printer Diagnostics > Output device diagnostics > Staple test b Select a staple job. Is the job stapled? Go to step 5. Go to step 4. Step 4 a Check the staple finisher staple unit for proper installation and damage, and replace if necessary. See “Staple finisher staple unit removal”. b Reseat the cables on both ends of the staple unit. Does the problem remain? Go to step 5. The problem is solved. Step 5 Check the cables for cuts or any damages, and replace if necessary. Does the problem remain? Go to step 6. The problem is solved. Step 6 a Check the staple finisher staple unit ejector for damage, and replace if necessary. See “Staple finisher staple unit ejector removal”. b Check the ejector for proper installation and operation. Make sure to clear the area of any obstructions. Does the problem remain? Go to step 7. The problem is solved. Step 7 a Check the staple finisher staple cartridge door for damage, and replace if necessary. See “Staple finisher staple cartridge door removal”. b Check the door for proper installation. Make sure that it closes correctly. Does the problem remain? Go to step 8. The problem is solved. Step 8 Reseat all cable connectors in the staple finisher controller board, and then reset the printer. Does the problem remain? Contact the next level of support. The problem is solved.