Code: 110.20...110.92
Description: 110.20 Printhead error (mirror motor lock is asserted) was detected before the motor was turned on. 110.21 No printhead power (+5V) when the laser servo started. 110.31 Printhead error (no first Hysnc) was detected. 110.32 Printhead error (lost first Hysnc) was detected. 110.33 Printhead error (lost first Hysnc) was detected during servo. 110.34 Printhead error (mirror motor lost lock) was detected. 110.35 Printhead error (mirror motor no first lock) was detected. 110.36 Printhead error (mirror motor never stabilized) was detected. 110.41 Printhead NVRAM read failure occurred. 110.70 Printhead NVRAM values were incorrect. 110.91 Printhead timing error was detected. 110.92 Printhead NVRAM checksum mismatch occurred.
Remedy: Step 1 Reset the printer. Does the problem remain? Go to step 2. The problem is solved. Step 2 Check the controller board sockets JWPR1 and JVD01 connections. Are the cables properly connected? Go to step 4. Go to step 3. Step 3 Reseat the cables. Does the problem remain? Go to step 4. The problem is solved. Step 4 Check the printhead connections. Is the printhead properly connected? Go to step 6. Go to step 5. Step 5 Reseat the cables. Does the problem remain? Go to step 6. The problem is solved. Step 6 Check the printhead cables for damage. Are the cables free of damage? Go to step 8. Go to step 7. Step 7 Replace the cables. Does the problem remain? Go to step 8. The problem is solved. Step 8 Reset the printer. Does the problem remain? Go to step 9. The problem is solved. Step 9 Replace the printhead. See “Printhead removal”. Does the problem remain? Go to step 10. The problem is solved. Step 10 Reset the printer. Does the problem remain? Go to step 11. The problem is solved. Step 11 Replace the controller board. See “Controller board removal”. Does the problem remain? Contact the next level of support. The problem is solved.