Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 147.01...147.05 — Lexmark CX310dn

Code: 147.01...147.05

Description: 147.01 Service Staging Motor Staging motor has exceeded the ramp up table. 147.02 Service Staging Motor Staging motor has exceeded number of encoders at minimum PWM. 147.03 Service Staging Motor Staging motor has exceeded number of encoders at maximum PWM. 147.04 Service Staging Motor Motor encoder count did not change between interrupts. 147.05 Service Staging Motor Staging motor has encountered a stall time out.
Remedy: Step 1 Turn the printer off, and then remove the rear cover. See “Rear cover removal”. Check the table at JSP1 on the controller board for proper connection. Is the cable properly connected? Go to step 3. Properly connect the cables, and POR the printer. Go to step 2.
Step 2 Did the printer function correctly after reconnecting the cables? Problem resolved. Go to step 3.
Step 3 Turn the printer on, and then verify the following approximate values at JSP1: Pin 2: +24 V dc Pin 4: +24 V dc Pin 5: +5 V (when paper is picked) Pin 7: Ground Pin 8: Ground Pin 10: +5 V dc Pin 12: _5 V dc (when paper is picked) Pin 15: +5 V dc Pin 16: Ground Are the values approximately correct? Replace the paper pick motor drive assembly. See “Paper pick motor drive assembly (standard tray) removal”. Replace the controller board. See “Controller board removal”.

← Xem tất cả mã lỗi Lexmark CX310dn

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie