Code: 950.xx
Description: NVRAM failure There is a mismatch between controller EEPROM and mirror. 950.00 through 950.29 codes: mismatch between controller and mirror 950.30 through 950.60 codes: mismatch between secure and controller
Remedy: Step 1 For CS310 models, has the operator panel with UICC card been replaced recently? For CS410 and CS510 models, has the UICC card been replaced recently? Replace the operator panel assembly with a new, and not previously installed, UICC card. Go to step 2.
Step 2 Has the controller board been replaced recently? Replace the controller board with a new, and not previously installed, controller board. See “Controller board removal”. Go to step 3.
Step 3 Turn the printer power off for ten or more seconds. Then, turn the printer back on (POR the printer). Is the error gone, and can the printer print? Problem solved. Go to step 4.
Step 4 Clear the NVRAM of the printer: a Turn the printer power off. b With the printer off, press and hold 6,7, and 8 on the keypad. c Turn the printer on. d When Restoring Factory Defaults appears, release the buttons. Note: If the printer looks up on the Restoring Factory Defaults, then wait two minutes, and then turn the printer power off. After ten seconds or more, turn the printer power back on without holding down any buttons. Does the error message still appear? Go to step 5. Problem solved.
Step 2 Has the controller board been replaced recently? Replace the controller board with a new, and not previously installed, controller board. See “Controller board removal”. Go to step 3.
Step 3 Turn the printer power off for ten or more seconds. Then, turn the printer back on (POR the printer). Is the error gone, and can the printer print? Problem solved. Go to step 4.
Step 4 Clear the NVRAM of the printer: a Turn the printer power off. b With the printer off, press and hold 6,7, and 8 on the keypad. c Turn the printer on. d When Restoring Factory Defaults appears, release the buttons. Note: If the printer looks up on the Restoring Factory Defaults, then wait two minutes, and then turn the printer power off. After ten seconds or more, turn the printer power back on without holding down any buttons. Does the error message still appear? Go to step 5. Problem solved.