Code: 110
Description: 110.20 Printhead error was detected before the motor was turned on. 110.21 No printhead power when the laser servo started. 110.31 Printhead error (no first Hysnc) was detected. 110.32 Printhead error (lost first Hysnc) was detected. 110.33 Printhead error (lost first Hysnc) was detected during servo. 11.34 Printhead error (mirror motor lost lock) was detected. 110.35 Printhead error (mirror motor no first lock) was detected. 110.36 Printhead error (mirror motor never stabilized) was detected. 110.41 Printhead NVRAM read failure occurred. 110.70 Printhead NVRAM values were incorrect. 110.71 Printhead timing measurement error was detected. 110.90 Video cable unplugged. 110.91 Printhead timing reading error was detected. 110.92 Printhead NVRAM checksum mismatch occurred.
Remedy: Step 1 Reset the printer. Does the problem remain? Go to step 2. The problem is solved. Step 2 Check the cables on the printhead and on the JMIRR1 and JPH1 connectors on the controller board for proper connection. Are the cables properly connected at both ends? Go to step 4. Go to step 3. Step 3 Reconnect the cables. Does the problem remain? Go to step 4. The problem is solved. Step 4 Check the printhead cable for damage, and replace if necessary. Does the problem remain? Go to step 5. The problem is solved. Step 5 Replace the printhead. See “Printhead removal”. Does the problem remain? Go to step 6. The problem is solved. Step 6 Replace the controller board. See “Controller board removal”. Does the problem remain? Contact the next level of support. The problem is solved.