Code: 240.33
Description: Paper fed from tray 3 was picked but it never arrived at the sensor (MPF/pass-through).
Remedy: Step 1 a From the home screen, touch Settings > Device > Preferences. b Check if the paper size matches the size set on the tray guides. Does the paper size match the size set on the tray? Go to step 3. Go to step 2. Step 2 Change the paper size or adjust the size setting in the tray. Does the problem remain? Go to step 3. The problem is solved. Step 3 a Enter the Diagnostics menu, and then navigate to: Printer diagnostics & adjustments > Sensor tests b Find the sensor (MPF/pass.through). Does the sensor status change while toggling the sensor? Go to step 6. Go to step 4. Step 4 Check the sensor cable for proper connection and damage, and replace if necessary. Does the problem remain? Go to step 5. The problem is solved. Step 5 Check the sensor for damage and replace if necessary. Does the problem remain? Go to step 6. The problem is solved. Step 6 a Enter the Diagnostics menu, and then navigate to: Printer diagnostics & adjustments > Sensor tests b Find the sensor (Pass.through (tray 2)). Does the sensor status change while toggling the sensor? Go to step 9. Go to step 7. Step 7 Check the sensor cable for proper connection and damage, and replace if necessary. Does the problem remain? Go to step 8. The problem is solved. Step 8 Check the sensor for damage and replace if necessary. See gSensor (550-sheet tray pass-through) removalh. Does the problem remain? Go to step 9. The problem is solved. Step 9 a Enter the Diagnostics menu, and then navigate to: Printer diagnostics & adjustments > Motor tests > Passthrough (tray 2) b Select a setting, and then touch Start. Does the motor run? Contact the next level of support. Go to step 10. Step 10 Check the motor cable for proper connection and damage, and replace if necessary. Does the problem remain? Go to step 11. The problem is solved. Step 11 a Replace the motor (550-sheet tray pass.through). See gMotor (550-sheet tray pass.through) removalh. b Perform a print job. Does the problem remain? Contact the next level of support. The problem is solved.