Description: 145.80 The motor (CMY photoconductors) did not turn on. 145.81 The motor (CMY photoconductors) did not turn off. 145.82 The motor (CMY photoconductors) speed did not ramp up to the required level. 145.83 The motor (CMY photoconductors) stalled. 145.84 The motor (CMY photoconductors) ran too slow. 145.85 The motor (CMY photoconductors) ran too fast.
Remedy: Step 1 Reset the printer. Does the problem remain? Go to step 2. The problem is solved. Step 2 Check the controller board socket JMAG1 connection. Is the cable properly connected? Go to step 4. Go to step 3. Step 3 Reseat the cable. Does the problem remain? Go to step 4. The problem is solved. Step 4 Check the motor (black only retract) connection. Is the motor properly connected? Go to step 6. Go to step 5. Step 5 Reseat the cable. Does the problem remain? Go to step 6. The problem is solved. Step 6 Check the motor (black only retract) cable for damage. Is the cable free of damage? Go to step 8. Go to step 7. Step 7 Replace the cable. Does the problem remain? Go to step 8. The problem is solved. Step 8 Reset the printer. Does the problem remain? Go to step 9. The problem is solved. Step 9 Replace the motor (black only retract). Does the problem remain? Go to step 10. The problem is solved. Step 10 Reset the printer. Does the problem remain? Go to step 11. The problem is solved. Step 11 Replace the controller board. See “Controller board removal”. Does the problem remain? Contact the next level of support. The problem is solved.