Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 426.13...426.55 — Lexmark CX825de

Code: 426.13...426.55

Description: 426.13 The motor (staple finisher aligner paddle) fails to reach home at the specified time. 426.15 The motor (staple finisher aligner paddle) fails to reach home at the specified time. 426.51 The motor (staple finisher aligner paddle) does not turn off. 426.54 The motor (staple finisher aligner paddle) fails to achieve expected speed. 426.55 The motor (staple finisher aligner paddle) runs too fast.
Remedy: Step 1 a Reset the printer. b Reseat the staple finisher. c Clear the paper path of any obstructions. Does the problem remain? Go to step 2. The problem is solved. Step 2 a Enter the Diagnostics menu, and then navigate to: Output device diagnostics > Sensor tests > Staple Finisher > Compile and staple section b Find the sensor (Decurl). Does the sensor status change while toggling the sensor? Go to step 4. Go to step 3. Step 3 a Check the sensor (staple finisher decurl) for proper installation and damage, and replace if necessary. See “Sensor (staple finisher decurl) removal”. b Reseat the connector on both ends. Does the problem remain? Go to step 4. The problem is solved. Step 4 a Enter the Diagnostics menu, and then navigate to: Output device diagnostics > Motor tests b Find the motor (Decurl), and then touch Start. Does the motor run? Go to step 6. Go to step 5. Step 5 a Check the motor (staple finisher decurl) for proper installation and damage, and replace if necessary. See “Staple finisher decurl assembly removal”. b Reseat the end of the connector that is on the controller board. Does the problem remain? Go to step 6. The problem is solved. Step 6 Replace the staple finisher decurl paddle. See “Staple finisher decurl assembly removal”. Does the problem remain? Go to step 7. The problem is solved. Step 7 Check the cables for cuts or damage, and replace if necessary. Does the problem remain? Go to step 8. The problem is solved. Step 8 Reseat all cable connectors in the controller board, and then reset the printer. Does the problem remain? Go to step 9. The problem is solved. Step 9 Replace the controller board. See “Staple finisher controller board removal”. Does the problem remain? Contact the next level of support. The problem is solved.

← Xem tất cả mã lỗi Lexmark CX825de

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie