Description: 130.80 The motor (printhead wiper) did not turn on. 130.81 The motor (printhead wiper) did not turn off. 130.82 The motor (printhead wiper) speed did not ramp up to the required level. 130.83 The motor (printhead wiper) stalled. 130.84 The motor (printhead wiper) ran too slow. 130.85 The motor (printhead wiper) ran too fast.
Remedy: Step 1 Reset the printer. Does the problem remain? Go to step 2. The problem is solved. Step 2 Check the controller board socket JWPR1 connection. Is the cable properly connected? Go to step 4. Go to step 3. Step 3 Reseat the cable. Does the problem remain? Go to step 4. The problem is solved. Step 4 Check the motor (printhead wiper) connection. Is the motor properly connected? Step 5 Reseat the cable. Does the problem remain? Go to step 6. The problem is solved. Step 6 Check the motor (printhead wiper) cables for damage. Are the cables free of damage? Go to step 8. Go to step 7. Step 7 Replace the cables. Does the problem remain? Go to step 8. The problem is solved. Step 8 Reset the printer. Does the problem remain? Go to step 9. The problem is solved. Step 9 Replace the motor (printhead wiper). Does the problem remain? Go to step 10. The problem is solved. Step 10 Reset the printer. Does the problem remain? Go to step 11. The problem is solved. Step 11 Replace the controller board. See “Controller board removal”. Does the problem remain? Contact the next level of support. The problem is solved.