Code: 200.01, 200.02
Description: 200.01 Media remains on the sensor (input) during the warm.up sequence. 200.02 Media reached the sensor (input) sooner than the specified time. The wrong config ID causes the engine to assume a 550 paper path on a 250 model.
Remedy: Step 1 Check the media path for partially fed or jammed media. Is the media path free from partially fed or jammed media? Go to step 2. Remove any prestaged or jammed media.
Step 2 Check the sensor (input) for proper operation. a Enter the diagnostic mode. b Select Base sensor test. c Observe the line item input. Does the display on the operator panel change every time the sensing area of the above sensor is interrupted or blocked? Go to step 4. Go to step 3.
Step 3 Check the above sensor for proper connection. Is the above sensor connected properly? Replace the Sensor (input). See “Sensor (input) removal”. Go to step 4. Reseat the connection. Go to step 4.
Step 4 Perform a print test. Does the problem remain? Contact the next highest level of tech support. Problem resolved.
Step 2 Check the sensor (input) for proper operation. a Enter the diagnostic mode. b Select Base sensor test. c Observe the line item input. Does the display on the operator panel change every time the sensing area of the above sensor is interrupted or blocked? Go to step 4. Go to step 3.
Step 3 Check the above sensor for proper connection. Is the above sensor connected properly? Replace the Sensor (input). See “Sensor (input) removal”. Go to step 4. Reseat the connection. Go to step 4.
Step 4 Perform a print test. Does the problem remain? Contact the next highest level of tech support. Problem resolved.