Code: 940.xx
Description: RIP to engine communication failure—the zero crossing signal used for fuser control in the low voltage (LV) power supply has failed, or the wrong low voltage power supply has been installed.
Remedy: Step 1 Check if the power supply cable is properly connected to the controller board. Is it properly connected? Go to step 2. Reseat the cables.
Step 2 a Turn off the printer. b Remove the power cord. c Measure the resistance between terminals A and D of the power supply socket. Is the resistance approximately 30 ohms? Contact your next level of support. Replace the power supply. See “Power supply removal”.
Step 2 a Turn off the printer. b Remove the power cord. c Measure the resistance between terminals A and D of the power supply socket. Is the resistance approximately 30 ohms? Contact your next level of support. Replace the power supply. See “Power supply removal”.