Code: 200.01
Description: Input sensor covered during warm-up sequence.
Remedy: Step 1 Check the input sensor area for jammed media fragments. Is the paper path free of partially fed or jammed media? Go to step 2. Clear the paper path of any media fragments.
Step 2 Check the jam access cover if it is blocking the input sensor. Is it blocking the input sensor? Replace the jam access cover. See “Jam access cover removal”. Go to step 3.
Step 3 Check the input sensor cable for proper connection. Is it properly connected? Go to step 4. Reseat the cable.
Step 4 POR into the Diagnostics menu and perform a sensor test: Diagnostics Menu > Base Sensor Test > Input. Does the sensor state on the control panel display change when it is toggled? Go to step 5. Replace the input sensor. See “Duplex sensor and input sensor removal”
Step 5 Does the error remain? Contact the next level of support. The problem is solved.
Step 2 Check the jam access cover if it is blocking the input sensor. Is it blocking the input sensor? Replace the jam access cover. See “Jam access cover removal”. Go to step 3.
Step 3 Check the input sensor cable for proper connection. Is it properly connected? Go to step 4. Reseat the cable.
Step 4 POR into the Diagnostics menu and perform a sensor test: Diagnostics Menu > Base Sensor Test > Input. Does the sensor state on the control panel display change when it is toggled? Go to step 5. Replace the input sensor. See “Duplex sensor and input sensor removal”
Step 5 Does the error remain? Contact the next level of support. The problem is solved.