Code: 133.01, 133.03, 133.04
Description: 133.01 The toner density is above normal. 133.03 The sensor (toner density) malfunctioned. 133.04 The sensor (toner density) did not perform the correct adjustments.
Remedy: Step 1 Enter the Diagnostics menu, and then navigate to: PRINTER SETUP > Reset Engine Service Error Does the problem remain? Go to step 2. The problem is solved. Step 2 Enter the Diagnostics menu, and then navigate to: Reset Image Stabilization > Restore factory toner density Does the problem remain? Go to step 3. The problem is solved. Step 3 Enter the Configuration menu, and then navigate to: Automatic Image Stabilization > Auto Align Adj Make sure that the value is set to On. Does the problem remain? Go to step 4. The problem is solved. Step 4 a Make sure that the developer is properly installed. b Make sure that the developer is supported. Does the problem remain? Go to step 5. The problem is solved.