Code: 171.03...171.07
Description: Fuser fan error.
Remedy: Step 1 a Make sure that the cable JFAN1 is properly connected to the controller board. b Check if the cooling fan is rotating properly. Is it rotating properly? Go to step 2. Replace the cooling fan. See “Cooling fan removals”.
Step 2 a Turn off the printer, and disconnect JFAN1 from the controller board. b Turn on the printer, and measure the voltage across JFAN1. Is the voltage approximately 24 V? Go to step 3. Replace the controller board. See “Controller board removals”.
Step 3 Is the fan idle? Replace the cooling fan. See “Cooling fan removals”. The problem is solved.
Step 2 a Turn off the printer, and disconnect JFAN1 from the controller board. b Turn on the printer, and measure the voltage across JFAN1. Is the voltage approximately 24 V? Go to step 3. Replace the controller board. See “Controller board removals”.
Step 3 Is the fan idle? Replace the cooling fan. See “Cooling fan removals”. The problem is solved.