Code: 192.10
Description: The tray 2 lift plate did not move to the correct position.
Remedy: Step 1 Enter the Diagnostics menu, and then navigate to: PRINTER SETUP > Reset Engine Service Error Does the problem remain? Go to step 2. The problem is solved. Step 2 Enter the Diagnostics menu, and then navigate to: MOTOR TESTS > PRINTER MOTOR TESTS > Tray 2 lift Does the motor run? Go to step 5. Go to step 3. Step 3 a Reseat the tray 2 lift motor cable. b Check the cable for damage, and replace if necessary. Does the problem remain? Go to step 4. The problem is solved. Step 4 Replace the motor (tray 2 lift). Does the problem remain? Go to step 5. The problem is solved. Step 5 a Make sure that the tray set sensor actuator is properly installed. b Check the actuator for damage, and replace if necessary. Does the problem remain? Go to step 6. The problem is solved. Step 6 Check the sensor (tray 2 lift plate level). Is it free of damage? Go to step 7. Go to step 9. Step 7 Enter the Diagnostics menu, and then navigate to: SENSOR TESTS > PRINTER SENSOR TESTS > Tray 2 lift plate limit Does the sensor status change while toggling the sensor? Go to step 10. Go to step 8. Step 8 a Reseat the tray 2 lift plate level sensor cable. b Check the cable for damage, and replace if necessary. Does the problem remain? Go to step 9. The problem is solved. Step 9 Replace the sensor (tray 2 lift plate level). Does the problem remain? Go to step 10. The problem is solved. Step 10 Check the engine controller board pins for damage, and replace if necessary. See “Engine controller board removal”. Does the problem remain? Contact the next level of support. The problem is solved.