Code: 163.04
Description: The motor (tray 3 feed) did not reach the required speed.
Remedy: Step 1 Enter the Diagnostics menu, and then navigate to: PRINTER SETUP > Reset Engine Service Error Does the problem remain? Go to step 2. The problem is solved. Step 2 a Check the tray 3 feed belt for proper tension, and adjust if necessary. b Check the feed belt and gears for wear or damage, and replace if necessary. See “2 x 500-sheet tray 3 transport belts and gears removal”. Does the problem remain? Go to step 3. The problem is solved. Step 3 Check the tray 3 feed, pick, and separator rollers for wear or damage, and replace if necessary. Note: If the page count is over 50K, then clean the rollers. Does the problem remain? Go to step 4. The problem is solved. Step 4 Replace the motor (2 x 500-sheet tray 3 feed). See “2 x 500-sheet tray feed and transport motors removal”. Does the problem remain? Go to step 5. The problem is solved. Step 5 Check the 2 x 500-sheet tray controller board pins for damage, and replace if necessary. See “2 x 500-sheet tray controller board removal”. Does the problem remain? Contact the next level of support. The problem is solved.