Code: 196.10
Description: The 2500-sheet tray lift plate did not move to the correct position.
Remedy: Step 1 Enter the Diagnostics menu, and then navigate to: PRINTER SETUP > Reset engine Service Error Note: Do this step every time a service error would occur to clear the error and restore the engine settings. Does the error remain? Go to step 2. The problem is solved. Step 2 a Make sure that the motor (2500-sheet tray elevator) is properly installed. b Enter the Diagnostics menu, and then navigate to: Motor Tests > 2500-Sheet Tray Motor Tests > Elevator Test c Observe if the motor is working properly. Note: Remove tray 1 and tray 2 to observe the motor movement properly. Does the motor run? Go to step 6. Go to step 3. Step 3 a Reseat the 2500-sheet tray elevator motor cable on both sides. b Check the motor cable for damage, and replace if necessary. Does the problem remain? Go to step 4. The problem is solved. Step 4 a Check the coupling for wear or damage, and replace if necessary. b Check the motor gears, rollers, and belts for wear or damage, and replace if necessary. Does the problem remain? Go to step 5. The problem is solved. Step 5 Replace the motor (2500-sheet tray elevator). See gMotor (2500.sheet tray elevator) removalh. Does the problem remain? Go to step 6. The problem is solved. Step 6 a Make sure that the actuators of the sensor (tray elevator home) and sensor (main tray elevator limit) are properly installed and aligned. b Check the actuators for damage, and replace if necessary. Does the problem remain? Go to step 7. The problem is solved.