Code: 163.04
Description: The motor (2500-sheet tray paper feed) did not reach the required speed.
Remedy: Step 1 Enter the Diagnostics menu, and then navigate to: PRINTER SETUP > Reset engine Service Error Note: Do this every time a service error would occur to clear the error and restore the engine settings. Does the error remain? Go to step 2. The problem is solved. Step 2 a Check the 2500-sheet tray feed and transport motor belt for proper tension, and adjust if necessary. b Check the 2500-sheet tray feed and transport motor gear and belt for wear or damage, and replace if necessary. Does the problem remain? Go to step 3. The problem is solved. Step 3 Check the 2500.sheet tray feed, pick, and separator rollers for damage, and replace if necessary. See g2500-sheet tray paper feed assembly removalh and g2500-sheet tray pick assembly removalh. Note: If the page count is over 50K, then clean the rollers. Does the problem remain? Go to step 4. The problem is solved. Step 4 Replace the motor (2500-sheet tray feed). See gMotor (2500.sheet tray feed) removalh. Does the problem remain? Go to step 5. The problem is solved. Step 5 Check the 2500-sheet tray controller board pins for damage, and replace if necessary. See “2500-sheet tray controller board removal”. Does the problem remain? Contact the next level of support. The problem is solved.