Code: 244.91, 245.91
Description: 244.91 The sensor (3000-sheet tray feed) did not detect the paper. 245.91 The paper remains detected at the sensor (3000.sheet tray transport) after the printer is turned on.
Remedy: Step 1 a Open the top door. b Make sure that the tray is free of debris. c Make sure that the tray is properly installed and aligned to the printer. d Reseat the interface cable that is plugged into the 2500. or 2 x 500.sheet tray. e Reset the printer. Does the problem remain? Go to step 2. The problem is solved. Step 2 a Make sure that the feed, separator, and pick rollers are properly installed. b Make sure that the rollers are free of debris or dust. c Check the rollers for wear or damage, and replace if necessary. Does the problem remain? Go to step 3. The problem is solved. Step 3 a Remove the left top cover. b Make sure that the transport roller is properly installed. c Make sure that the roller is free of debris or dust. d Check the roller for wear or damage, and replace if necessary. See g3000-sheet tray feed roller assembly removalh. Does the problem remain? Go to step 4. The problem is solved. Step 4 a Make sure that the following sensors are properly installed: . Sensor (3000-sheet tray elevator level) . Sensor (3000-sheet tray empty) . Sensor (3000-sheet tray feed) b Make sure that the sensors are free of debris or dust. c Reseat the cable on the sensors and the cable CN5 on the controller board. d Check the sensors for damage. Are they free of damage? Go to step 5. Go to step 6. Step 5 Enter the Diagnostics menu, and then navigate to: SENSOR TESTS > 3000.Sheet Tray Sensor Tests > Tray upper limit or Tray paper feed Does the sensor status change while toggling the sensor? Go to step 7. Go to step 6. Step 6 Replace the sensor. See gSensor (3000-sheet tray elevator level) removalh or gSensor (3000-sheet tray feed) removalh. Does the problem remain? Go to step 7. The problem is solved. Step 7 Test the motor (3000-sheet tray feed) and motor (3000-sheet tray transport). Enter the Diagnostics menu, and then navigate to: MOTOR TESTS > 3000-Sheet Tray Motor Tests > Tray feed or Tray transport Do the motors run? Go to step 9. Go to step 8. Step 8 a Reseat the cable on the motor and the cable CN4 on the controller board. b Check the motors and cables for damage, and replace if necessary. See g3000-sheet tray feed and transport motors removalh. Does the problem remain? Go to step 9. The problem is solved. Step 9 Check the belts and gears connected to the motors for wear or damage, and replace if necessary. Does the problem remain? Go to step 10. The problem is solved. Step 10 a Reseat the cable on the rest of the sensors. b Reseat the cable CN5 on the controller board. c If necessary, reseat all the junction connectors on the cables. d Make sure that the cables do not block the path of moving parts. e Check the cables for damage, and replace if necessary. Does the problem remain? Go to step 11. The problem is solved. Step 11 a Reseat the cable on the rest of the motors and on the top door switch. b Reseat the cables CN3 and CN4 on the controller board. c If necessary, reseat all the junction connectors on the cables. d Make sure that the cables do not block the path of moving parts. e Check the cables for damage, and replace if necessary. Does the problem remain? Contact the next level of support. The problem is solved.