Code: 193.10
Description: The tray 3 lift plate did not move to the correct position.
Remedy: Step 1 Enter the Diagnostics menu, and then navigate to: PRINTER SETUP > Reset Engine Service Error Does the problem remain? Go to step 2. The problem is solved. Step 2 Enter the Diagnostics menu, and then navigate to: MOTOR TESTS > 2 x 500-Sheet Tray Motor Tests > Tray 3 lift Does the motor run? Go to step 5. Go to step 3. Step 3 a Reseat the motor cable. b Check the cable for damage, and replace if necessary. Does the problem remain? Go to step 4. The problem is solved. Step 4 Replace the motor. See gMotor (2 x 500-sheet tray lift) removalh. Does the problem remain? Go to step 5. The problem is solved. Step 5 a Make sure that the tray 3 tray set actuator is properly installed. b Check the actuator for damage, and replace if necessary. g2 x 500.sheet tray tray set actuator removalh. Does the problem remain? Go to step 6. The problem is solved. Step 6 Check the sensor (2 x 500-sheet tray 3 lift plate level). Is it free of damage? Go to step 7. Go to step 9. Step 7 Enter the Diagnostics menu, and then navigate to: SENSOR TESTS > 2 x 500-Sheet Tray Sensor Tests > Tray 3 lift plate limit Does the sensor status change while toggling the sensor? Go to step 10. Go to step 8. Step 8 a Reseat the sensor cable. b Check the cable for damage, and replace if necessary. Does the problem remain? Go to step 9. The problem is solved. Step 9 Replace the sensor (2 x 500-sheet tray 3 lift plate level). See g2 x 500-sheet tray transport assembly sensors removalh. Does the problem remain? Go to step 10. The problem is solved. Step 10 Check the 2 x 500.sheet tray controller board pins for damage, and replace if necessary. See g2 x 500-sheet tray controller board removalh. Does the problem remain? Contact the next level of support. The problem is solved