Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 923, 924 — Lexmark Optra C710

Code: 923, 924

Description: 923 Fuser Error Fuser is too hot during printing or when printer is idle. 924 Fuser Error Indicates that the system has detected that the thermistor is open.
Remedy: 1 Fuser: • Assembly • Hot Roll • Backup Roll Bearings Check the fuser assembly for signs of overheating or damage, especially the hot roll and backup roll. Also check for contaminants such as label glue or excessive toner buildup. • If contaminants are found, repair as necessary or replace the fuser assembly. • If damage from overheating is found, replace the fuser. 2 Thermistor Assembly Engine Board Check for a shorted thermistor by measuring across the connector located in the cable guide. • If the thermistor is shorted, replace the thermistor. • If replacing the failing thermistor does not fix the problem, replace the engine board. Check for signs of damage or contamination to the thermistor assembly. If no problem is found, check the resistance of the thermistor. Hot: CN18-1 to CN18-2: Approximately 2.0k - 2.5k ohms Cold: Approximately 150k to 250k ohms If incorrect, replace the thermistor. Check for an open in the thermistor circuit in the fuser assembly. Be sure the thermistor is properly connected to the thermistor cable in the bottom of the cable guide.

← Xem tất cả mã lỗi Lexmark Optra C710

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie