Code: 16
Display: Printhead Cannot Move Remove any obstructions to the printhead inside the printer, then press OK.
Description: Print Carrier Stall
Remedy: Turn off the All-In-One. Open the printer cover, and clear the carrier path from any obstruction. If the problem remains, then replace the All-In-One.
Printhead cannot move appears on the LCD, and the printhead stops nearly at thecenter or at the NS wiper. • Check the encoder strip for ink contamination, wear, damage, or looseness. If damaged, then replace the encoder strip with spring. Go to “Encoder strip with spring removal”. • Check the carrier outer FCC cable connected to J21. If properly connected, then replace the carrier assembly with belt and cables. Go to “Carrier assembly with belt and cables removal”. Printhead cannot move appears on the LCD, and there is no carrier movement. Check the carrier belt for worn, damage, or looseness. If damaged, then replace the carrier belt. Go to “Carrier assembly with belt and cables removal”. Printhead not supported by the All-in-One appears on the LCD. • Check the carrier inner FCC cable connected to J23. • Check the carrier middle FCC cable connected to J22. If any of these is properly connected, then replace the carrier assembly with belt and cables. Go to “Carrier assembly with belt and cables removal”.
Printhead cannot move appears on the LCD, and the printhead stops nearly at thecenter or at the NS wiper. • Check the encoder strip for ink contamination, wear, damage, or looseness. If damaged, then replace the encoder strip with spring. Go to “Encoder strip with spring removal”. • Check the carrier outer FCC cable connected to J21. If properly connected, then replace the carrier assembly with belt and cables. Go to “Carrier assembly with belt and cables removal”. Printhead cannot move appears on the LCD, and there is no carrier movement. Check the carrier belt for worn, damage, or looseness. If damaged, then replace the carrier belt. Go to “Carrier assembly with belt and cables removal”. Printhead not supported by the All-in-One appears on the LCD. • Check the carrier inner FCC cable connected to J23. • Check the carrier middle FCC cable connected to J22. If any of these is properly connected, then replace the carrier assembly with belt and cables. Go to “Carrier assembly with belt and cables removal”.