Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 6000 — Kyocera ECOSYS P6030cdn

Code: 6000

Description: Broken fuser heater lamp wire The detected fuser thermistor temperature does not rise 1C/1.8F after the fuser heater lamp has been turned on continuously for 10 seconds in warming up. The fuser temperature does not reach 100C/212F after the fuser heater lamp has been turned on continuously for 40 seconds in warming up. The detected temperature of fuser thermistor does not reach the specified temperature (ready indication temperature) after fuser heater lamp has been turned on continuously for 90 seconds in warming up. The detected temperature of fuser thermistor 2 does not rise 1C/1.8F after fuser heater lamp has been turned on continuously for 10 seconds during printing.
Remedy: Defective harness between fuser thermistor and paper exit PWB (YC4), or improper connector insertion. Reinsert the connector. Also check for continuity within the connector harness. If none, remedy or replace the harness.
Defective harness between paper exit PWB (YC1) and engine PWB (YC20), or improper connector insertion. Reinsert the connector. Also check for continuity within the connector harness. If none, remedy or replace the harness.
Fuser thermistor installed incorrectly. Replace the fuser unit.
Fuser thermal cutout triggered. Replace the fuser unit.
Fuser heater lamp installed incorrectly. Replace the fuser unit.
Broken fuser heater lamp wire. Replace the fuser unit.
Defective engine PWB. Replace the engine PWB.

← Xem tất cả mã lỗi Kyocera ECOSYS P6030cdn

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie