Code: 5103
Description: Main high-voltage error M (40 ppm model) When adjusting Vpp in the main charger adjustment, the inflowing current of the drum unit (M) is excessively low.
Remedy: Drum unit 1. Confirm that the drum or the drum screw can rotate. 2. If it won’t rotate, replace the drum unit.
Main charger roller unit 1. Confirm that the Main charger roller unit has been firmly attached. 2. Replace the Main charger roller unit.
High-voltage PWB 1. Confirm that the wiring connector is firmly connected, and if necessary, connect the connector all the way in. High-voltage PWB (YC101) and Main/ Engine PBW (YC7) 2. If the wiring is disconnected, short-circuited or has ground fault, replace the wire. 3. Replace the High-voltage PWB.
Main/Engine PWB 1. Check both main and engine firmware, and upgrade to the latest version, if necessary. 2. Replace the Main/Engine PWB.
Main charger roller unit 1. Confirm that the Main charger roller unit has been firmly attached. 2. Replace the Main charger roller unit.
High-voltage PWB 1. Confirm that the wiring connector is firmly connected, and if necessary, connect the connector all the way in. High-voltage PWB (YC101) and Main/ Engine PBW (YC7) 2. If the wiring is disconnected, short-circuited or has ground fault, replace the wire. 3. Replace the High-voltage PWB.
Main/Engine PWB 1. Check both main and engine firmware, and upgrade to the latest version, if necessary. 2. Replace the Main/Engine PWB.