Code: C0170
Description: Charger count error The values in one of the billing counters or the life counter mismatch between the main side and the engine side.
Remedy: 1 Checking the machine serial No. of the main PWB The main PWB for the different main unit is installed. Check the machine serial Nos of MAIN and ENGINE at U004, and install the correct main PWB if the MAIN No. differs. Note: Be sure not to execute U004 if the machine serial No. differs from the machine serial No. indicated on the main unit to prevent the different machine serial No. from overwritten. (Dontselect[Execute]andpressth e[Start]key.)' Maintenanc e Mode List Detaching and reattaching the Main PWB 2 Checking the machine serial No. in the EEPROM on the engine PWB The EEPROM for the different main unit is installed. Check the machine serial Nos of MAIN and ENGINE at U004, and install the correct EEPROM on the engine PWB if the ENGINE machine serial No. differs. Maintenanc e Mode List Detaching and reattaching the EEPROM (Section 4 "Notes when replacing the engine PWB") 3 Checking the main PWB The main PWB is faulty. When the MAIN machine serial No. differs at U004, replace the main PWB and execute U004. Maintenanc e Mode List Detaching and reattaching the Main PWB 4 Checking the EEPROM on the engine PWB The EEPROM is faulty. When the machine serial No. in the engine PWB differs at U004, reattach the EEPROM on the engine PWB. If not repaired, replace the EEPROM and execute U169.Then, compare to previously output U000 maintenance report, re-enter the setting value for U053, U100, U101, U106, U140, U161, U464, U252, U034, and execute the maintenance mode in following order. U119 > U469[Manual] > U140[AC Calib] > U464[Calib] > U155[Calibration] (prepare the empty waste toner box) Maintenanc e Mode List Detaching and reattaching the EEPROM (Section 4 "Notes when replacing the engine PWB") 5 Replacing the engine PWB The engine PWB is faulty. Replace the engine PWB. Detaching and reattaching the Engine PWB