Code: C1010
Description: Lift motor 1 error Five times consecutive detection of any one of the below condition. 1. Lift upper limit sensor 1 does not detect on even 16s passed after inserting cassette 1. 2. After turning on lift motor 1, lock signal does not release for 300ms. 3. After detecting lift upper limit sensor 1 OFF during printing, lift upper limit sensor 1 does not turn on even passing 1s from ascending control.
Remedy: 1 Checking the lift plate The lift plate does not operate properly. Repair or replace the lift plate when it does not move vertically. 2 Checking the drive gear The drive gear to lift up the lift plate does not rotate properly. Check if the lift plate lift-up drive gears rotate smoothly or have no excessive load. And apply the grease (EM-50LP, Part no.: 7BG010009H) to the sliding section and repair the related parts so that they can rotate smoothly. 3 Checking the connection The connector is not connected properly, or the wire is faulty. Clean the terminal of the following wire connectors and reconnect the connectors. If there is no continuity, replace the wire. . Lift motor 1 - Feed drive PWB . Feed drive PWB - Engine PWB Section 8 "PWBs" 4 Checking lift motor 1 Lift motor 1 is faulty. Check the operation of lift motor 1, and replace it if necessary. Detaching and reattaching the Lift Motor 5 Checking the connection The connector is not connected properly, or the wire is faulty. Clean the terminal of the following wire connectors and reconnect the connectors. If there is no continuity, replace the wire. . Lift upper limit sensor 1 - Feed drive PWB . Feed drive PWB - Engine PWB Section 8 "PWBs" 6 Checking lift sensor 1 Lift upper limit sensor 1 is not properly attached, or it is faulty. Reattach lift upper limit sensor 1. Replace it if it is not fixed. 7 Replacing the feed drive PWB The feed drive PWB is faulty. Replace the feed drive PWB. 8 Firmware upgrade The firmware is not the latest version. Upgrade the engine firmware to the latest version Firmware Update 9 Replacing the engine PWB The engine PWB is faulty. Replace the engine PWB. Detaching and reattaching the Engine PWB