Code: C1030
Description: PF lift motor 1 error (Paper Feeder) Object: Paper feeder or Large capacity feeder [PF-7100 (Paper Feeder)] 1. PF lift upper limit sensor 1 does not turn on after passing 16s since cassette 3 was inserted. 2. The lock-up signal is not released for 300ms after turning on of PF lift motor 1. 3. Since PF lift sensor 1 turned off during printing, PF lift upper limit sensor 1 does not turn on after passing 1s from the ascend control. [PF-7110 (Large Capacity Feeder)] 1. PF lift upper limit sensor 1 does not turn on after passing 24s since cassette 3 was inserted. 2. PF lift upper limit sensor 1 does not turn on after passing 3s from the ascend control when starting printing.
Remedy: 1 Checking the PF lift plate The PF lift plate does not operate properly. Repair or replace the PF lift plate when it does not move vertically. 2 Checking the drive gear The drive gear to lift up the PF lift plate does not rotate properly. Check if the PF lift plate lift-up drive gears rotate smoothly or have no excessive load. And apply the grease (EM-50LP, Part no.: 7BG010009H) to the sliding section and repair the related parts so that they can rotate smoothly. 3 Checking the connection The connector is not connected properly, or the wire is faulty. Clean the terminal of the following wire connectors and reconnect the connectors. If there is no continuity, replace the wire. . PF lift motor 1 - PF PWB Section 8 "PWBs" 4 Checking PF lift motor 1 PF lift motor 1 is faulty. Replace PF lift motor 1. 5 Checking the connection The connector is not connected properly, or the wire is faulty. Clean the terminal of the following wire connectors and reconnect the connectors. If there is no continuity, replace the wire. . PF lift upper limit sensor 1 - PF PWB Section 8 "PWBs" 6 Checking PF lift sensor 1 PF lift upper limit sensor 1 is not properly attached, or it is faulty. Reattach PF lift upper limit sensor 1. Then, replace it if it is not fixed. 7 Replacing the PF PWB The PF PWB is faulty. Replace the PF PWB. Detaching and reattaching the PF PWB