Code: C2102
Description: Developer motor CY error 1. After the developer motor CY drive starts, the ready signal does not reach to L level even passing 2s. 2. After the developer motor CY stabilizes, the ready signal shows H level for 2s continuously.
Remedy: 1 Checking the developer drive section The developer drive section is faulty. Replace the developer unit drive gear if it is faulty. 2 Checking the developer roller The developer roller is faulty. Check if the developer roller rotates, and replace the developer unit if not rotating. Detaching and reattaching the Developer Unit 3 Checking the drive parts The drive from the developer motor is not transmitted properly. Execute U030 [DLP(CMY)] to check the developer motor CY operation. Check if the drive gears rotate and have no excessive load, and apply the grease (EM-LP, Part no: 7BG010009H) to the sliding section and repair the related parts so that they can rotate smoothly. Maintenance Mode List 4 Checking the connection The connector is not connected properly, or the wire is faulty. Clean the terminal of the following wire connectors and reconnect the connectors. If there is no continuity, replace the wire. . Developer motor CY - Feed image PWB . Feed image PWB - Engine PWB Section 8 "PWBs" 5 Checking the developer motor The developer motor is faulty. Reattach developer motor CY. If not repaired, replace it. 6 Replacing the feed image PWB The feed image PWB is faulty. Replace the feed image PWB. 7 Firmware upgrade The firmware is not the latest version. Upgrade the engine firmware to the latest version Firmware Update 8 Replacing the engine PWB The engine PWB is faulty. Replace the engine PWB. Detaching and reattaching the Engine PWB