Code: C2810
Description: Waste toner motor error 1. The lock detection signal shows L level during driving the waste toner motor. (0.5s x 3 times retry continuously with 2ms cycle) 2. Low level of the lock detection signal can not detect within 50ms from the switching REM signal L to H. (3 times retry with 50ms cycle)
Remedy: 1 Checking the waste toner box The waste toner box is not properly installed. Reinstall the waste toner box. Replacing the Waste Toner Box (Operation Guide - Section 10) 2 Checking the waste toner motor The waste toner motor does not operate properly. Execute U030 [Toner Recovery] to check whether the waste toner motor operation has an excessive load or not. Then, repair it if necessary. Maintenanc e Mode List 3 Checking the drive gear The drive gear does not rotate properly. Check if the excessive load is not applied to the drive gears by rotating the gears, and clean the drive gears and the bushing, etc. 4 Replacing the waste toner box The waste toner box is faulty. Replace the waste toner box. Replacing the Waste Toner Box (Operation Guide - Section 10) 5 Checking the waste toner motor The waste toner motor is not properly connected. Reinsert the connector into the waste toner motor. 6 Checking the connection The connector is not connected properly, or the wire is faulty. Clean the terminal of the following wire connectors and reconnect the connectors. If there is no continuity, replace the wire. . Waste toner motor - Engine PWB Section 8 "PWBs" 7 Firmware upgrade The engine firmware is faulty. Upgrade the engine firmware to the latest version Firmware Update 8 Replacing the engine PWB The engine PWB is faulty. Replace the engine PWB. Detaching and reattaching the Engine PWB