Code: C2840
Description: Belt cleaning motor error 1. FG pulse of the motor does not enter for 2s continuously during driving the motor. 2. FG pulse exceeding 4000rpm was detected 10 times continuously. 3. The condition where the target speed +/-6.25% of the motor deviated continued for 2s.
Remedy: 1 Checking the primary transfer unit The primary transfer unit is not properly installed. Reinstall the primary transfer unit. Detaching and reattaching the Primary Transfer Unit 2 Cleaning the primary transfer cleaning section The roller in the primary transfer cleaning section does not rotate properly. Remove the waste toner remaining in the primary transfer cleaning section. 3 Checking the connection The connector is not connected properly, or the wire is faulty. Clean the terminal of the following wire connectors and reconnect the connectors. If there is no continuity, replace the wire. . Belt cleaning motor - Transfer PWB . Transfer PWB - Transfer connect PWB . Transfer connect PWB - Feed image PWB . Feed image PWB - Feed drive PWB . Feed image PWB - Engine PWB Section 8 "PWBs" 4 Checking the belt cleaning motor The belt cleaning motor does not operate properly. Reattach the belt cleaning motor. If not repaired, replace it. 5 Primary transfer unit replacement The cleaning drive section of the primary transfer unit is faulty. Transfer PWB or transfer connection PWB is faulty. Replace the primary transfer unit. Detaching and reattaching the Primary Transfer Unit 6 Replacing the feed image PWB The feed image PWB is faulty. Replace the feed image PWB. 7 Firmware upgrade The engine firmware is faulty. Upgrade the engine firmware to the latest version Firmware Update 8 Replacing the engine PWB The engine PWB is faulty. Replace the engine PWB. Detaching and reattaching the Engine PWB 8 Replacing the feed drive PWB The feed drive PWB is faulty. Replace the feed drive PWB.