Code: C6000
Description: IH heating error 1 After warm-up is started, the center thermistor does not reach 100°C / 212°F even 60s passed. Or, during the warm-up, specified temperature (Ready display temperature) is not detected even 420s passed after center thermistor reached 100°C / 212°F.
Remedy: 1 Executing U169 The IH setting mismatches the power supply specification. Set the destination same as the voltage of the IH PWB at U169. Maintenanc e Mode List 2 Removing foreign material There are foreign objects between the fuser unit and the fuser IH unit. Or, the foreign objects are adhered on the fuser belt. If there are foreign objects between the fuser unit and the fuser IH unit, or on the fuser belt, remove them. After that, reinstall the fuser unit. Detaching and reattaching the Fuser Unit 3 Reinstalling the fuser unit The foreign objects adhere on the drawer connection terminal of the fuser unit. Or, the drawer connector is not inserted completely. Clean the drawer connection terminal of the fuser unit. Check the pin of the drawer connector is not bent, and replace the fuser unit if it is bent. If the pin is normal, reinstall the fuser unit so that the drawer connector is securely connected. Detaching and reattaching the Fuser Unit 4 Firmware upgrade The firmware is not the latest version. Upgrade the engine firmware to the latest version Firmware Update 5 Checking the connection The connector is not connected properly, or the wire is faulty. Clean the terminal of the following wire connectors and reconnect the connectors. If there is no continuity, replace the wire. . Drawer connector of the fuser unit - Feed image PWB . Feed image PWB - Engine PWB . Fuser IH unit - IH PWB . IH PWB - Engine PWB Section 8 "PWBs" 6 Replacing the fuser unit The temperature cannot be detected properly due to the broken thermostat or the thermistor error. Replace the fuser unit. Detaching and reattaching the Fuser Unit 7 Replacing the engine PWB The engine PWB is faulty. Replace the engine PWB. Detaching and reattaching the Engine PWB 8 Replacing the feed image PWB The feed image PWB is faulty. Replace the feed image PWB. 9 Checking the connection The connector is not connected properly, or the wire is faulty. Clean the terminal of the following wire connectors and reconnect the connectors. If there is no continuity, replace the wire. . Fuser IH unit - IH PWB . IH PWB - Engine PWB Section 8 "PWBs" 10 Replacing the IH PWB The IH PWB is faulty. Replace the IH PWB. Detaching and reattaching the IH PWB