Description: Eject/IH fan motor error The lock-up was detected for 20s continuously when driving the fan motor.
Remedy: 1 Checking the connection The connector is not connected properly, or the wire is faulty. Execute U037 [Exit Paper IH Coil]. If the following fan motor does not operate properly, clean the terminal of the connector and reconnect the connector. If there is no continuity, replace the wire. . Exit/IH front fan motor - Feed image PWB . Exit/IH middle fan motor - Feed image PWB . Exit/ IH rear fan motor - Feed image PWB . Feed image PWB - Engine PWB Maintenanc e Mode List Section 8 "PWBs" 2 Checking the eject/IH fan motors The eject/IH fan motors do not properly operate. Clean the following fan motors, and remove foreign objects if they adhere on the fan motor. If not repaired after that, replace the fan motor. . Exit/IH front fan motor . Exit/IH middle fan motor . Exit/IH rear fan motor Fan Motors Attachable Direction 3 Firmware upgrade The firmware is not the latest version. Upgrade the engine firmware to the latest version Firmware Update 4 Replacing the feed image PWB The feed image PWB is faulty. Replace the feed image PWB. 5 Replacing the engine PWB The engine PWB is faulty. Replace the engine PWB. Detaching and reattaching the Engine PWB