Code: C7602
Description: Rear ID sensor error Dark potential error: Sensor output value (RearDarkP, RearDarkS) is less than 0.15V or bigger than 0.80V. Bright potential error: RearBrightS is less than RearDarkS or RearBrightP is less than RearDarkP+0.5V.
Remedy: 1 Cleaning the rear ID sensor The rear ID sensor is dirty. Clean the rear ID sensor surface. 2 Checking the ID sensor shutter The ID sensor shutter does not operate properly. Execute U033 [ID Sensor]. If the ID sensor shutter does not operate properly, reattach the cleaning solenoid. Maintenanc e Mode List 3 Checking the connection The connector is not connected properly, or the wire is faulty. Clean the terminal of the following wire connectors and reconnect the connectors. If there is no continuity, replace the wire. . Rear ID sensor - Feed drive PWB . Cleaning solenoid - Feed drive PWB . Feed drive PWB - Engine PWB Section 8 "PWBs" 4 Replacing the cleaning solenoid The cleaning solenoid is faulty. Replace the cleaning solenoid. 5 Checking the rear ID sensor The rear ID sensor is not properly attached. Reattach the rear ID sensor. 6 Replacing the rear ID sensor The rear ID sensor is faulty. Check if the value of U465 [T7 CTD] is fluctuated before and after Calibration, and replace the rear ID sensor if it was not fluctuated (uncalibrated). Maintenanc e Mode List 7 Firmware upgrade The firmware is not the latest version. Upgrade the engine firmware to the latest version Firmware Update 8 Replacing the feed drive PWB The feed drive PWB is faulty. Replace the feed drive PWB. 9 Replacing the engine PWB The engine PWB is faulty. Replace the engine PWB. Detaching and reattaching the Engine PWB