Code: F010
Description: Program read error (SSD) The garbled 2bit data was detected during the program read from the flash memory.
Remedy: 1 (When the service call error appears after replacing the SSD) Replacing the SSD along the correct procedures The firmware is not stored in the SSD. Insert the USB memory device containing all released firmware into the main unit, and turn the main power on. Firmware Update 2 Checking the SSD (if lit after replacing the SSD) An SSD out of specification is installed. Install the SSD matching the memory capacity specification. 3 Resetting the main power The communication between the main PWB and the operation panel main PWB is faulty. Turn off the power switch and the main power switch. After 5 seconds, turn on the main power switch and the power switch. 4 Checking the SSD The SSD is not installed properly. Check if there is an error on the terminal of the SSD and Clean. After that, reconnect SSD. Detaching and reattaching the SSD 5 Checking the connection The connector is not connected properly. Or, the wire or the SATA cable is faulty. Clean the below wire, the terminal of SATA cable connector and reconnect them. If there is no continuity, replace the wire. . Main PWB - Operation panel main PWB Section 8 "PWBs" 6 Executing U021 The backup RAM data is faulty. Execute U021 to initialize the backup RAM data. Maintenanc e Mode List 7 Replacing the SSD The SSD is faulty. Execute U026 to back up the SSD data. After that, replace SSD and turn on the power while USB memory that contains the firmware for the appropriate model is inserted to the main unit. Maintenanc e Mode List Detaching and reattaching the SSD 8 Replacing the main PWB The main PWB is faulty. Replace the main PWB. Detaching and reattaching the Main PWB