Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 6000 — Kyocera FS3920DN

Code: 6000

Description: Broken fuser heater lamp wire
The temperature does not reach 100°C/ 212°F after the fuser heater lamp has been turned on continuously for 30 s. 35/37 ppm printer (EUR/USA model): The temperature does not rise by 1°C/ 1.8°F after the fuser heater lamp has been turned on continuously for 5 s during printing. 40/42 and 45/47 ppm printers (EUR/USA model): The temperature does not rise by 1°C/ 1.8°F after the fuser heater lamp has been turned on continuously for 10 s during warm-up or at standby.
Causes: Poor contact in the fuser thermistor 1 connector terminals. Fuser thermistor 1 installed incorrectly. Thermal cutout triggered. Fuser heater lamp installed incorrectly. Broken fuser heater lamp wire.
Remedy: Poor contact in the fuser thermistor 1 connector terminals. Reinsert the connector.
Fuser thermistor 1 installed incorrectly. Check and reinstall if necessary.
Thermal cutout triggered. Check for continuity. If none, replace the thermal cutout.
Fuser heater lamp installed incorrectly. Check and reinstall if necessary.
Broken fuser heater lamp wire. Check for continuity. If none, replace the fuser heater lamp

← Xem tất cả mã lỗi Kyocera FS3920DN

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie