Code: 6000
Description: fixing heater lamp/fixing thermistor error
• The fixing thermistor disconnection detection circuit in the engine/high voltage PWB outputs the disconnection detection signal (THDEAD) to the CPU more than a specified time after power is turned on. • The fixing temperature does not rise at least 1 °C when the fixing heater lamp is continuously on for approximately 20 seconds during printer warm-up or in the standby mode. • The fixing temperature does not rise at least 1 °Cwhen the fixing heater lamp is continuously on for approximately 15 seconds during printing. • The fixing temperature does not lower when the fixing heater lamp is off for a specified time or more. * The fixing temperature is the average value calculated using the input voltage from the fixing thermistor detected several times in a specified time to avoid influence of noise and so on.
• The fixing thermistor disconnection detection circuit in the engine/high voltage PWB outputs the disconnection detection signal (THDEAD) to the CPU more than a specified time after power is turned on. • The fixing temperature does not rise at least 1 °C when the fixing heater lamp is continuously on for approximately 20 seconds during printer warm-up or in the standby mode. • The fixing temperature does not rise at least 1 °Cwhen the fixing heater lamp is continuously on for approximately 15 seconds during printing. • The fixing temperature does not lower when the fixing heater lamp is off for a specified time or more. * The fixing temperature is the average value calculated using the input voltage from the fixing thermistor detected several times in a specified time to avoid influence of noise and so on.