Code: EA5
Description: Finisher stapling jam
Remedy: MJ-1011 Is there any paper remaining on the transport path in the finisher or main unit or on the stapling tray? YES Remove the paper. NO Is the jam cleared by taking off the staple cartridge from the finisher and removing the staple sheet sliding it from the staple case? YES End NO Is the connector J8 on the finisher controller PC board disconnected? Is the harness connecting the finisher controller PC board and stapling home position sensor (S17D) open-circuited? YES Connect the connector securely. Replace the harness. NO Is the stapling home position sensor working properly? NO 1. Connect the connector of the stapling home position sensor securely. 2. Replace the stapling home position sensor. YES Replace the finisher controller PC board.
MJ-1012/1013 (Finisher section) Is there any paper remaining on the transport path in the finisher or main unit, or on the stapling tray? YES Remove the paper. NO Is the jam cleared by taking off the staple cartridge from the finisher and removing the staple sheet sliding it from the staple case? YES End NO Is the connector J8 on the finisher controller PC board disconnected? Is the harness connecting the finisher controller PC board and staple home position sensor (PI22) open-circuited? YES Connect the connector securely. Replace the harness. NO Is the staple home position sensor working properly? NO 1. Connect the connector of the staple home position sensor securely. 2. Replace the staple home position sensor. YES Replace the finisher controller PC board.
MJ-1012/1013 (Finisher section) Is there any paper remaining on the transport path in the finisher or main unit, or on the stapling tray? YES Remove the paper. NO Is the jam cleared by taking off the staple cartridge from the finisher and removing the staple sheet sliding it from the staple case? YES End NO Is the connector J8 on the finisher controller PC board disconnected? Is the harness connecting the finisher controller PC board and staple home position sensor (PI22) open-circuited? YES Connect the connector securely. Replace the harness. NO Is the staple home position sensor working properly? NO 1. Connect the connector of the staple home position sensor securely. 2. Replace the staple home position sensor. YES Replace the finisher controller PC board.